Herunterladen Inhalt Inhalt Diese Seite drucken

Installing The Parts To Be Built In - Mountfield IBIZA Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4.8

Installing the parts to be built in

If the water surface is approximately 20 cm below the
respective part, you can start trimming and installing
(or completing the installation) of the parts to be built
in.
4.8.1
Return nozzle
For attaching a hose 32/38 mm (see Fig. 76):
When the plastic swimming pool sheet is smooth, cut
it just in front of the opening in the wall for the return
nozzle (the cut-off part should be 5-10 mm smaller
than the opening in the steel wall). Then put a gasket
between the sheet and the steel wall and pass the
nozzle with the second gasket through the opening
so that gaskets are present in front of and behind the
plastic sheet. Now tighten the nozzle with the safety
nut on the outer side of the swimming pool.
Important: If a double gasket has been
provided, separate it in the middle to obtain
two separate gaskets (see Fig. 75).
For fixed piping 50 mm (see Fig. 77):
Once the plastic pool sheet is smooth, make holes for
the screws, with an awl for instance (see Fig. 79). Fix
the other gasket behind the flange so that it is
positioned between the liner and the flange. Tighten
the flange screws transversely.
Now cut out a hole in the liner copying the opening
(see Fig. 83). Re-tighten the nozzle eye and adjusting
ring and put on the cover.
Fig. 75
Fig. 76
24
Fig. 77
Fig. 78
Fig. 79

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis