Steel Wall Installation - Mountfield IBIZA Montageanleitung

4.3

Steel wall installation

If you want to be able to get into the swimming pool,
you will need swimming pool steps/stairs or a ladder.
Later, when installing the liner, be cautious for the
construction ladder not to damage the liner.
Furthermore, bring the coiled steel wall into the
swimming pool before installing it.
With the assistance of your helpers move the steel
wall roughly to the point where the skimmer (surface
impurity collector) should be installed and put it onto
thick boards and cartons to facilitate its uncoiling (see
Fig. 20). When uncoiling the steel wall, do NOT drag
it over the concrete foundation, it might get damaged.
The steel wall is coiled inwards in the
factory so the outer side is visible on the
coiled steel wall.
So, uncoil the steel wall in the direction in which it has
been coiled.
In order to prevent injury, wear gloves when uncoiling
and mounting the steel wall and use straps to control
the uncoiling process. (see Fig. 21).
The recess for the
beginning of the uncoiling steel wall (approx. 1–2 m
from the front end). If the steel wall is packed in more
than one package, it is shown on the boxes which
steel wall parts (with which recesses for the structure
parts) are included.
Fig. 20
Uncoil the steel wall and slide it into the edge trims
(see Figs. 22–23). The skimmer recess must be
positioned as required (as close to the filter system
as possible).
The return nozzle is located left of the skimmer
(viewed from outside).
If a joining section is present on one side of the steel
wall, it must be slid out.
Where large swimming pools are concerned, the
steel wall is divided into 2 parts and the joining
procedure using the sliding-in section is performed
twice.
Fig. 21
12
skimmer is normally located at the
Fig. 22
Fig. 23