Swimming Pool Installation; Circular Swimming Pool Installation - Mountfield IBIZA Montageanleitung

Fix the polystyrene boards 20 mm thick to the internal
side of the retaining walls by using an adhesive for
polystyrene. A 25 mm offset above the base slab
must be left free for the bottom edge trims (Fig. 13).
1) Polystyrene board
2) Bottom edge trim
3) Base slab
Important: If swimming pool lights are
planned to be installed, openings for this
installation must be made/prepared
during the retaining wall building
process. Follow manufacturer's
instructions.
4

Swimming pool installation

4.1

Circular swimming pool installation

Depending on the swimming pool size, its installation
is a job for 3–4 persons and should be made in
windless conditions. The use of gloves during the
steel wall construction is recommended.
First, draw the swimming pool contour on the ground.
This will immensely facilitate the swimming pool siting
and installation procedures . For this, fasten a string
to a nail driven into the centre of the future pool and
measure the radius (= one-half of the diameter). Use
a piece of chalk or a bricklayer's pencil to mark the
radius measured with the string – see Figs. 14 and15:
The bottom and top wall edge trims are provided. You
will find them inside the coiled steel wall.
Fig. 13
4.1.1 Installation of the bottom wall edge trims
Combine the bottom edge trim segments (approx. 20
mm wide) into one unit by means of the joining tubes
and put the closed swimming pool contours on the
ground. Proceed by following the ground plan.
Check precisely the dimensions and symmetry.
Professional hint for the installation of the
bottom edge trims (and later also the top
edge trims): Combination of the segments
into one unit will be much easier if the pins
are greased.
For this, insert a pin into one segment, grease the still
protruding side (see Fig. 16) and combine the edge
trims (Fig. 17).
10
Fig. 14
Fig. 15