Mountfield IBIZA Montageanleitung Seite 15

Depending on the swimming pool type the sliding-on
section may have a side bevelled. If this is the case,
put the sliding-in section with the bevelled side
directed inside and upwards. If none of the sides is
bevelled, there is no difference between the
top/bottom sides.
Facilitate the section installation by moving it slightly
up and down periodically. The use of a rubber
hammer can also be convenient.
However, if the section is put on incorrectly and/or
driven down with too much force, the steel wall may
get damaged (and the validity of the warranty may be
limited) and the swimming pool stability may be
compromised.
Covering the internal sliding-in section surface with
Fig. 30
an adhesive tape is recommended in order to protect
the swimming pool liner from damage.
Additional information regarding oval swimming
pools: Steel wall attachment
It is assumed in this explanation that the retaining
wall height is as described on page 9.
In the area of the retaining walls the steel wall must
be fastened to the retaining wall edge with screws (at
a height of 110 cm or 140 cm from the ground for a
swimming pool 120 cm or 150 cm high, respectively).
The fastening must be in a horizontal line. Use the
screws, wall plugs and try squares provided for this
operation (see Fig. 34).
Fig. 31
Drill the holes in the steel wall. Grind the hole edges
smooth and coat with an anticorrosion paint.
Fig. 32
14
Fig. 33
Fig. 34
Fig. 35