Hanging The Pool Liner And Installing The Top Wall Edge Trim - Mountfield IBIZA Montageanleitung

Professional hint for laying the padding:
Subsequently, small wedges at a spacing of
20-25 cm must be cut out of the padding
edge in the oval segment in order to remove
any excess material (see Figs. 58–59).
Any folds in the padding from the transport and
storage will get smooth eventually under the pressure
of the swimming pool water.
4.7 Hanging the pool liner and
installing the top wall edge trim
Caution: Install the pool liner at +15°C to
+25°C. Avoid exposure to strong solar
radiation!
If the temperature is too high, the plastic material is
soft and elastic and the liner is too large. If the
temperature is too low, the plastic material is hard
and inelastic and the liner is too small (the size
differences can make up to 50 cm!).
If the padding is present on the pool bottom, enter the
swimming pool only in clean shoes or in socks. Also,
the entire internal swimming pool area should be
cleaned again (with a vacuum cleaner for instance,
Fig. 61).
Fig. 58
Now put the liner in the centre of the swimming pool
and spread it so that the outer floor seams should be
equally far from the steel wall because the plastic
material is soft and elastic and the liner is always
somewhat smaller than the swimming pool itself.
Fig. 59
See to it that the perpendicular weld should
not be in the area of the skimmer, return
nozzles or lights or else leaktightness
cannot be guaranteed.
Caution: Enter the swimming pool with
the liner inside only barefoot or in
suitable footwear.
Fig. 60
20
Fig. 61