Installation Of An Oval Swimming Pool - Mountfield IBIZA Montageanleitung

Professional hint for shortening the bottom
edge trims: First combine all the edge trims
into one and align as appropriate according
to the ground plan. Any overhanging ends
should be shortened only when building the
steel wall because only then the differences
in the dimensions are apparent and can be
trimmed as appropriate.
The precise procedure is shown in Figs. 28-30 on
page 13.
4.2 installation of an oval swimming
pool
First, draw the swimming pool contour on the ground.
The semi-circles of the rounding can be best marked
by means of a string fixed with the nail in the centre
of the future pool. Mark the lines with a bricklayer's
pencil or chalk. The swimming pool dimensions,
including the radius, are shown in Fig. 7 on page 7.
4.2.1 Installation of the bottom edge trims
First slide the straight bottom edge trim segments
(width approx. 20 mm) into one another. Lay the
straight parts of the bottom wall edge trim directly in
front of the brick wall, into the space in the
polystyrene, and centre the edge trims against the
brick wall length. The wall is very slightly longer.
Professional hint for laying the straight edge
trims symmetrically: Measure diagonally the
end points of the edge trims. The
dimensions will be identical if the edge trims
have been laid symmetrically. See
dimension "a" in Fig. 19.
Fig. 16
Join the bent bottom edge trim pieces and use them
to fill the rounded segments on the front sides.
Proceed by following the ground plan.
Check precisely the dimensions and symmetry.
Professional hint for shortening the bottom
wall edge trims: First combine all the edge
trims into one and align as appropriate
according to the ground plan. Any
overhanging ends should be shortened only
when building the steel wall because only
then the differences in the dimensions are
apparent and can be trimmed as
Fig. 17
appropriate. See section 4.4.
Fig. 18
11
Fig. 19