BMW 7 Serie E 38 Einbauanleitung Seite 44

RHD models only
Connect the 1-pin plug casing I1 on the adapter cable for RHD cars I to the 1-pin socket casing E and lay it to the
installation site of the gong (H10) on the left-hand side of the car. Connect the 1-pin socket casing I2 on the adap-
ter cable for RHD cars I to pin T4 on the gong (25).
Continue with Figure M on folded page 2-53.
M
Cars without a switch centre only
Carefully lever out the trim (27) with a screwdriver. Push the heater switch (28) through the switch aperture in the
direction indicated by the arrow and disconnect the connection plug.
Cars with a switch centre only
Carefully lever out the switch centre (not shown) with a screwdriver and disconnect the connection plug.
Push the heater switch (28) through the switch aperture in the direction indicated by the arrow and disconnect
the connection plug.
N
Cars without a switch centre only
Thread the 6-pin socket casing F through a switch aperture and connect it to the PDC switch (29).
Connect up connectors C and D to the power supply wiring harness as follows.
Select the grey/red cable with a cross-section of 0.5 mm
secure connector C using a miniature high-speed connector.
Select the brown/black cable with a cross-section of 0.5 mm
and secure connector D using a miniature high-speed connector.
Insert the PDC switch (29) in the switch aperture and cover the switch apertures you have not used with a trim to
match the interior of the car.
O
Cars with a switch centre only
Thread the 6-pin socket casing F through the aperture for the switch centre. Cut the brown/blue/yellow cable
and the brown/grey/yellow cable just above the socket casing F, strip them and crimp on the two 1-pin socket
contacts G1 and G2 as follows:
Crimp socket contact G1 to the brown/blue/yellow cable and connect it to the connection plug (30) (X1869) on the
switch centre, pin 9.
Crimp socket contact G2 to the brown/grey/yellow cable and connect it to the connection plug (30) (X1869) on the
switch centre, pin 8.
Cables C (grey/red) and D (brown/black) are not required, they are to be insulated and tied back.
The standard switch centre is to be replaced by the "High version" switch centre (complete switch/button
assignment).The switches and buttons not in use are to be covered with a blind cover.
2-38/EN
or 0.75 mm from a wiring harness under the radio and
2 2
or 0.75 mm from a wiring harness under the radio
2 2