Stryker IsoAir System Handbuch Seite 23

S S t t a a r r t t i i n n g g t t h h e e A A L L P P m m o o d d e e w w i i t t h h o o u u t t A A S S T T
ALP mode alternately inflates and deflates the A/B air cells to relieve pressure and allows for manual adjustment of air cell
pressure.
To start the ALP mode:
1. On the home screen, press the A A c c t t i i o o n n button next to the M M o o d d e e icon (Figure 13).
2. To start ALP mode, press the A A c c t t i i o o n n button next to the A A L L P P m m o o d d e e icon (Figure 14).
N N o o t t e e - - The support surface alternates between zone A and zone B in approximately six minute intervals.
3. Press the A A c c t t i i o o n n button next to the A A L L P P m m o o d d e e icon (Figure 15).
4. Press the A A c c t t i i o o n n button next the u u p p - - a a r r r r o o w w or d d o o w w n n a a r r r r o o w w to increase or decrease the ALP level from 1 to 5 (Figure
16).
2941-009-005 Rev A.0
F F i i g g u u r r e e 1 1 3 3 – – M M o o d d e e
F F i i g g u u r r e e 1 1 4 4 – – A A L L P P m m o o d d e e o o f f f f
F F i i g g u u r r e e 1 1 5 5 – – A A L L P P m m o o d d e e o o n n
19 EN