Additional Safety Instructions; Residual Risks - Parkside PBSA 12 D2 Originalbetriebsanleitung

7) ADDITIONAL SAFETY
INSTRUCTIONS
a) Hold the appliance by the
insulated gripping surfac-
es when performing work
in which the tool may
come into contact with
hidden wiring. Contact with
a live wire can also cause a
charge in metal parts of the ap-
pliance and result in an electric
shock.
b) Hold the device by the in-
sulated gripping surfaces
when performing work in
which the cutting tool may
come into contact with
hidden wiring or its own
cord. If the screw were to come
into contact with a live electrical
cable, metal parts of the appli-
ance could also become live
and cause an electric shock.
c) Do not use any accessories that
are not recommended by PARK-
SIDE. This can result in electric
shock or fi re.
8) SAFETY INFORMATION
FOR USING LONG DRILLS
a) Do not work at a speed
higher than the maximum
permissible speed for the
drill. Higher speeds can cause
the drill to bend slightly when
rotating freely without contact
with the workpiece and can
also cause injury.
b) Always begin drilling at
a low speed and when
the drill is in contact with
the workpiece. Higher
speeds can cause the drill to
bend slightly when rotating
freely without contact with the
workpiece and can also cause
injury.
c) Do not apply excessive
pressure to the drill. Only
apply pressure lengthwise
along the drill. Drills can
bend and break or cause a loss
in control, thus resulting in inju-
ries.

9) RESIDUAL RISKS

Even if properly operating and
handling this electric tool, some
residual risks will remain. Due to its
construction and build, this electric
tool may present the following haz-
ards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
GB IE
25