Set The Direction Of Rotation; Torque Setting; Tool Change; Keyless Drill Chuck Removal - Parkside PBSA 12 D2 Originalbetriebsanleitung

A gear change may only be per-
formed in standstill mode!
Set the direction of
rotation
You can select the direction of rotation with
the direction switch (clockwise and anti-
clockwise direction) and secure the device
against accidental start up.
1. Wait for the device to shut-down.
2. Clockwise direction: Press
direction switch (6) to the right.
3. Anticlockwise direction: Press
direction switch (6)
to the left.
4. Switch lock: Bring direction switch to
neutral position.
The direction changed may only be
performed in standstill mode.

Torque setting

You can preset the maximum torque by ro-
tating the torque adjustment ring (3).
19+1 torque levels are provided.
1. Turn the adjusting ring (3) to select the
desired torque:
Step 1 -->
Step -->
Screws:
Drilling:
2. Start with a lower torque step and in-
crease according to requirement.
Torque adjustment should only be
performed in standstill mode.
Reaching the preset torque limit pro-
duces a noticeable rasping sound.
lowest torque,
highest torque.
Steps 1 - 19
Step .
This sound is caused by the slip
clutch.

Tool change

1. Rotate the keyless chuck (1) towards
RELEASE until the drill chuck aperture
(11) is large enough to accommodate
the tool.
2. Push the tool as far as possible into the
keyless chuck (1).
3. Turn the keyless chuck towards
order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
Keyless drill chuck
removal
To use the bitholder (14), you must remove
the keyless chuck (1).
1. Hold the keyless chuck (1) tightly from
the front. Pull or push the drill chuck
ring (2) in the direction of the keyless
chuck (1).
2. This unlocks the keyless chuck (1) and it
can be pulled off from the front.
3. In order to put the keyless chuck (1)
back in position, pull the drill chuck
ring (2) in the direction of the keyless
chuck. Push the keyless chuck (1) on as
far as it will go.
When setting the keyless chuck, a
25 mm bit may remain in the bit
holder (14).
If the keyless chuck (1) does not
engage automatically, turn the drill
chuck ring (2).
GB IE
in
GRIP
27