Service; Safety Instructions For Drills - Parkside PWBSA 12 A1 Originalbetriebsanleitung

e) Do not use a damaged or modified battery.
Damaged or modified batteries may behave
unexpectedly and cause fires, explosions or
pose a risk of injury .
f) Do not expose a battery to fire or excessively
high temperatures. Fire or temperatures in
excess of 130°C (265°F) can cause an
explosion .
g) Follow all instructions regarding charging
and never charge the battery or the cordless
tool outside of the temperature range given in
the operating instructions. Incorrect charging
or charging outside of the permissible tempera-
ture range can destroy the battery and increase
the risk of fire .
CAUTION! RISK OF EXPLOSION!
Never charge non-rechargeable
batteries.
battery from heat (for example, from contin-
uous exposure to sunlight), fire, water and
moisture. There is a risk of explosion .

6 . Service

a) Have your power tool serviced by a qualified
specialist using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained .
b) Never try to repair damaged batteries.
Batteries should only be maintained by the
manufacturer or an approved customer
service centre .
■ 6 │ GB │ IE
Protect the rechargeable

Safety instructions for drills

Safety instructions for all work
■ Wear ear muffs.
Exposure to loud noise can lead to
hearing loss .
■ Hold the power tool only by the insulated
handles when you are carrying out work in
which the accessory tool or the screws may
come into contact with concealed power
cables. Contact with a live wire may electrify
exposed metal parts of the tool and could give
the operator an electric shock .
■
Wear a dust mask.
Safety information for using long drill bits
■
Do not use a higher rotational speed than the
maximum permissible speed. At higher
speeds, the drill bit can bend slightly if allowed
to turn freely without being in contact with the
workpiece, and this can lead to injuries .
■ Always start drilling at a low speed and with
the drill bit in contact with the workpiece. At
higher speeds, the drill bit can bend slightly if
allowed to turn freely without being in contact
with the workpiece, and this can lead to injuries .
■ Do not exert excessive pressure and only
apply pressure along the length of the drill bit
(no lateral pressure). Drill bits can bend and
break which can lead to a loss of control and
injuries .
PWBSA 12 A1