Attaching The Safety Chain (Of The Optional Spreader Bar) - probst SH-1000-MINI Bedienungsanleitung

Installation
4.6.1

Attaching the safety chain (of the optional spreader bar)

•
Lift the device with the sucked load just a little (approx.. 20 cm)
•
Then remove both safety chains from the chain cases of the spreader bar (TRA).
•
Throw the safety chains underneath the load (concrete slab) .
Never grip with the hands under load. - Caution: Danger of squeezing hands!!!
•
Suspend and tighten both safety chains as shown in picture 1. Place the end of the chains into the
chain cases.
•
The safety chains must fit tightly to the load, in that way that the load is held in case of a vacuum
failure (Fig. 1)
•
The safety chains must never hang loose under the load, otherwise the load may fall down, in case
of a vacuum failure (Fig. 2).
•
Now the device with sucked load be transported to the place of destination.
•
Lower the load carefully (distance to the ground approx. 20 cm), then remove safety chains and
throw it under the load.
•
Never grip with the hands under load (stone slab)! Danger of squeezing!!!
•
Safety chains should be returned to chain cases.
•
Put the device with the sucked load completely down on the floor.
Fig. 1
5240.0020
Fig. 2
V4
21 / 34
GB