Safety regulations
3.7. The noise emission of the machine
The noise emission during cutting is highly dependent on the material of the stone that is to be
cut.
The use of good hearing protection is required
3.8. Maintenance of the machine
The machine must be in a sufficient state of repair that no dangerous situations can occur. The
maintenance chart is provided in chapter 7. Use only original parts
3.9. Summary of the safety regulations
The machine may only be operated by qualified personnel.
As operator of the machine, you must be aware of the information that is relevant for
you in these operation and maintenance regulations. Refer to section 1.3
The operator is not permitted to perform operations that are not indicated to be
intended for the operator.
As maintainer of the machine, you must be aware of the information that is relevant for
you in these operation and maintenance regulations. Refer to section 1.3.
Always remain alert for possible dangerous situations. Be careful of projecting portions
of the machine. Be careful with loose clothing and hair.
Never engage power to the machine if any person is in contact with the machine in a
dangerous manner.
Never start the machine if any person is in contact with the machine in a dangerous
manner.
Switch off the machine before performing maintenance. Do so by disconnecting the
mains plug.
Follow the warnings and indications on the machine. For the explanation of the
symbols, see section 3.2.
It is absolutely forbidden to remove the warning symbols or make them unreadable by
any means. Worn warning symbols must be replaced in a timely manner.
The machine must be in a sufficient state of repair that no dangerous situations can
occur. The troubleshooting chart is provided in chapter 7.
Only sufficiently trained personnel may open protective shields to perform service. Also
refer to section 1.3.
14 / 21