Herunterladen Inhalt Inhalt Diese Seite drucken

Practicing Sitting Down And Standing Up; Practicing Walking; Attaching The Cosmetic Cover; Finishing The Prosthesis - Ottobock Prosedo 3R31 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6.4.2 Practicing sitting down and standing up

CAUTION
Adjusting the Settings
Fall due to incorrect or unfamiliar settings
Only adapt the settings to the patient gradually.
Explain the effects of the adjustments on the use of the prosthesis to the patient.
► The patient has to learn safe operation of the lock for all exercises (lock by loading at full
extension/unlock using the lock slide).
► CAUTION! With the patient, practice sitting down 
page 20).
3
 If the movement resistance is too low (flexion damping), the prosthetic knee joint has to be
adjusted as illustrated.
4
 If the movement resistance is too high (flexion damping), the prosthetic knee joint has to be
adjusted as illustrated.
► CAUTION! With the patient, practice standing up 
up, it is necessary to wait until the joint moves to extension again.

6.4.3 Practicing walking

► CAUTION! Using parallel bars or a handrail 
prosthetic knee joint is locked (see Fig. 
► NOTICE! Be sure to establish functional exterior foot rotation 
► Check the exterior rotation 
► Check socket flexion 
► Check socket adduction 

6.5 Attaching the cosmetic cover

CAUTION
Use of talcum
Falling, damage to the prosthetic knee joint due to lack of lubrication
Do not use talcum on the prosthetic knee joint or other prosthetic components.
► Attach the cosmetic cover as shown in Fig. 
1
 To maintain the positioning, only unscrew the two set screws that are screwed in the fur­
thest.
2
 The cosmetic cover must not interfere with the movement of the lock release cable.
3
 After completion, verify functioning of the lock.
4
 Check the functioning of flexion damping.
► To reduce friction and to eliminate noise, apply 519L5 Silicone Spray directly onto the contact
surfaces of the cosmetic foam cover.

6.6 Finishing the prosthesis

► CAUTION! To avoid product damage and the risk of falling, finish the prosthesis by replacing
set screws that are too short or too long, and by tightening the screw connections according
31
to Fig. 
on page 22.
29
4
of the prosthetic knee joint.
5
.
6
.
1
and standing up 
5
with a highly flexed joint. While standing
1
, practice walking 
on page 21).
3
.
30
on page 22, noting the following points:
2
(see Fig. 
2
with the patient while the
Ottobock | 45
28
on

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Prosedo 3r31-st

Inhaltsverzeichnis