List Of Pictograms Used Introduction; Intended Use - Parkside PMSG 200 A1 Montage-, Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Direct current
Rated value of the mains
U
voltage
1
MULTI-WELDER PMSG 200 A1
z Introduction
Congratulations! You have
purchased one of our high-quality
devices. Please familiarise yourself with
the product before setup or first use.
To do so, please read through the
following operating and safety instruc-
tions carefully. This tool must be set up
or used only by people who have been
trained to do so.
KEEP OUT OF THE REACH OF
CHILDREN!
z Intended use
The device is designed for MIG welding
(welding with welding wire and inert
gas), MMA welding (welding with rod
electrodes) and TIG welding (tungsten
inert gas welding). When using solid
wires which do not contain inert gas in
solid form, then you must use inert gas
in addition. When using aluminium solid
wire, then you must use argon as the
inert gas. When using self-shielding flux-
cored wire, you do not need to use any
additional gas. In this case, the inert
gas is contained in the welding wire in
powdered form and is therefore chan-
nelled straight into the arc. This means
that the device is not susceptible to wind
when working outdoors. Only suitable
wire electrodes may be used for the
device. This welding device is designed
for manual arc welding (MMA welding)
List of pictograms used / Introduction
Rated value of the open
U
circuit voltage
0
of steel, stainless steel, steel sheet,
galvanised metal and cast materials,
using the appropriate coated electrodes.
Refer to the information from the
electrode manufacturer. Only suitable
electrodes may be used for the device.
For tungsten inert gas welding (TIG
welding) it is essential that you observe
the operating and safety instructions for
the TIG torch you are using, in addition
to the instructions and safety instructions
in these operating instructions. If it is
not handled properly the product can
be dangerous for individuals, animals
and property. The welding mask must
only be used with protective welding
glasses as well as prescription glasses
which are marked appropriately, used
properly and as a general rule, are only
used for welding. The welding mask
is not designed for laser welding! Use
the product only as described and only
for the specific applications as stated.
Keep these instructions in a safe place.
Ensure you hand over all documentation
when passing the product on to anyone
else. Any use that differs to the intended
use as stated above is prohibited and
potentially dangerous. Damage or
injury caused by misuse or disregarding
the above warning is not covered by
the warranty or any liability on the part
of the manufacturer. The device has
been designed for household use only
and must not be used in commercial or
industrial applications. Commercial use
will void the guarantee. Observing the
safety instructions and assembly instruc-
tions and operating information in the
instructions for use is also a component
of the intended use.
GB/MT 63