Charging The Flight Battery - PARKZONE Extra 300 Bedienungsanleitung

Charging the Flight Battery

Your Extra 300 comes with a DC balancing charger and 3S
Li-Po battery. You must charge the included Li-Po battery
pack with a Li-Po specific charger only (such as the included
charger). Never leave the battery and charger unattended
during the charge process. Failure to follow the instructions
properly could result in a fire. When charging, ensure the
battery is on a heat-resistant surface. It is recommended to
charge the battery pack while you are assembling the aircraft.
The flight battery will be required to confirm proper aircraft
operation in future steps.
The Battery Charging Process
1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make sure it is not damaged
e.g., swollen, bent, broken or punctured.
2. Attach the input cord of the charger to the appropriate power supply (12V accessory outlet).
3. When the Li-Po charger has been correctly powered up, there will be an approximate 3-second delay, then an audible "beep"
and the green (ready) LED will flash.
4. Turn the control on the Amps selector so the arrow points to the charging rate required for the Battery (see chart, for
example the Extra 300s 2200mAh Li-Po battery will charge at 2.0 amps). DO NOT change the charge rate once the battery
begins charging.
5. Move the cell selector switch to 3-cell for your battery.
6. Connect the Balancing Lead of the Battery to the 3-cell (it has 4 pins) charger port.
7. The green and red LEDs may flash during the charging process when the charger is balancing cells. Balancing prolongs the
life of the battery.
8. When the battery is fully charged, there will be an audible beep for about 3 seconds and the green LED will shine
continuously.
9. Always unplug the battery from the charger immediately upon completion of charging.
CAUTION: Overcharging a battery can cause a fire.
CAUTION: Only use a charger specifically designed to charge a Li-Po battery. Failure to do so could result in fire causing
injury or property damage.
CAUTION: Never exceed the recommended charge rate.
Downloaded from www.Manualslib.com manuals search engine
ONLY
®
DC Li-Po Balancing Charger Features
• Charges 2- to 3-cell lithium polymer battery packs
• Variable charge rates from 300mAh to 2-amp
• Simple single push-button operation
• LED charge status indicator
• LED cell balance indicator
• Audible beeper indicates power and charge status
• 12V accessory outlet input cord
Specifications
• Input power: 12V DC, 3-amp
• Charges 2- to 3-cell Li-Po packs with minimum
capacity of 300mAh
3S 11.1V 2200mAh Li-Po Battery Pack
• The ParkZone 3S Li-Po battery pack features a balancing
lead that allows you to safely charge your battery pack
when used with the included ParkZone Li-Po balancing
charger.
• Charge at rates up to 2.2 amps
CAUTION: The balance connector must be inserted into
the correct port of your charger prior to charging.
EN
5