Installing The Flight Battery In The Airplane; Transmitter And Receiver Binding - PARKZONE NIGHT VAPOR Bedienungsanleitung

Installing the Flight Battery in the Airplane

Once the Li-Po battery is fully charged, you can install it in the airplane. This is done by placing it into the
battery holder on the bottom of the fuselage. Make sure the plug faces the rear of the airplane.
Note: The battery holder can slide forward and backwards to allow for Center of Gravity adjustment.
Note: Always disconnect the Li-Po from the receiver of the airplane when not flying. Failure to
do so will render the battery unusable.

Transmitter and Receiver Binding

Your Night Vapor RTF comes pre-bound to the included DSM2/DSMX transmitter. If you should need to re-
bind your airplane follow the simple directions below.
Setting the Airplane for Binding
1. Make sure the flight battery is disconnected from the receiver unit and the transmitter is turned off.
2. Plug in the flight battery into the airplane. When the LED on the receiver begins to flash rapidly, then
immediately proceed to instruction for your transmitter below.
Note: Although the transmitter included in your Night Vapor is 4-channel capable, the airplane is a
3-channel aircraft with proportional throttle, elevator, and rudder control. For this reason, the
rudder control is on the right stick.
7