Installing Propeller Adapter, Propeller And Spinner - PARKZONE Extra 300 Bedienungsanleitung

EN

Installing Propeller Adapter, Propeller and Spinner

The information on this page is for maintenance of the Extra
300. Spinner, propeller and propeller adapter damage can
result from aircraft crashes.
CAUTION: DO NOT handle propeller parts while the flight
battery is connected. Personal injury could result.
1. Put the collet of the propeller adapter (PKZ5102) on the
motor shaft (PKZ5116).
Tip: Some force may be required to fully install the collet on
the motor shaft.
Note: The motor installed in the model may not look the same as the
2. Put the swash plate of the propeller adapter (PKZ5102) on
the collet shaft.
3. Put the spinner backplate (PKZ5107) on the swash plate of
the propeller adapter.
14
Downloaded from www.Manualslib.com
motor in photographs.
manuals search engine
4. Put the propeller (PKZ5101) on the collet of the propeller
adapter (PKZ5102).
NOTICE: The propeller (PKZ5101) side with the numbers for
diameter and pitch (for example 10.5 x 9) should face out
from the spinner backplate.
5. Put the hex nut of the propeller adapter (PKZ5102) on the
collet shaft.
6. Tighten the hex nut on the collet to hold the propeller and
propeller adapter on the motor (PKZ5116). A tool may be
required to tighten the nut (tool is not included).
7. Make sure spinner (PKZ5107) is fully seated on the spinner
backplate.
8. Install and tighten a screw in the spinner to hold the spinner
on the collet shaft.