General Assembly And Maintenance Tips - PARKZONE Extra 300 Bedienungsanleitung

EN

General Assembly and Maintenance Tips

NOTICE: This checklist is not a replacement for the content included in this manual. Although it can be used as a quick start
guide, you must read through this manual completely before proceeding.
First Flight Preparation

Remove and inspect contents
Begin charging flight battery
Assemble Extra 300
Install receiver
Connect servos to receiver or Y-harness
Install fully charged battery
Bind the receiver to a transmitter, if applicable
Perform the Control Direction Test with the transmitter
Adjust flight controls and transmitter
Adjust battery for center of gravity (CG) see page 14
Perform a radio system Range Check
Find a safe and open flying field
Plan flight for flying field conditions
Maintenance After Flying

Disconnect flight battery from ESC (Required for Safety)
Turn off transmitter (Required for Safety)
Remove flight battery from aircraft
Recharge flight battery
Clean aircraft (wipe off dirt, etc.)
Repair or replace all damaged parts
Carefully disassemble and store aircraft
Store flight battery apart from aircraft and monitor the battery charge
Make note of flight conditions and flight plan results, planning for future flights
6
Downloaded from www.Manualslib.com manuals search engine
Activity
Activity
PNP BNF
u u
u u
u u
u
u u
u u
u u
u u
u u
u u
u u
u u
u u
PNP BNF
u u
u u
u u
u u
u u
u u
u u
u u
u u