Installing Flight Battery And Adjusting Center Of Gravity - PARKZONE Extra 300 Bedienungsanleitung

Installing Flight Battery and Adjusting Center of
Gravity
Installing the Flight Battery
CAUTION: Before installing the flight battery, always install
the receiver and connect the speed control to the throttle
channel (PNP).
CAUTION: Always power on transmitter before connecting
battery.
1. Install the flight battery in the aircraft.
2. Connect the battery to the ESC.
3. Move the battery in the fuselage, either forward or to the
rear, to adjust the aircraft center of gravity for flight.
Downloaded from www.Manualslib.com manuals search engine
Forward placement of the battery (recommended)
Rear placement of the battery
4. Secure the flight battery using the hook and loop straps.
5. Make sure the wires in the fuselage do not block the canopy
hatch when closing the hatch.
Before flying and after the Control Direction Test has centered
the control surfaces, please re-bind the aircraft so the control
surfaces are neutral when connecting the flight battery.
Adjusting Center of Gravity (CG)
The CG location is 2 3/4 inches (76mm) back from leading edge
of the wing at the root +/- 1/4 inch (6.4mm). This CG location
has been determined with the ParkZone 2200mAh 11.1V 25C
Li-Po battery installed in the middle of the battery cavity.
When a nose-heavy (forward) or tail-heavy (rear) condition is
desired, move the battery forward or to the rear.
EN
11