Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BT-SM 1800 Originalbetriebsanleitung

Activate the release lever (3),
•
press the machine head (4)
downwards and secure with
the safety pin (25). The saw is
now locked in its bottom posi-
tion.
Fix the saw's drag function
•
with the locking screw for drag
guide (24) in rear position.
Carry the equipment by the
•
fixed saw table (18).
To set up the equipment
•
again, proceed as described
in section 5.2.
6.9 Operating the laser (Fig. 2)
To switch on: Move the ON/OFF
switch (37) to the "I" position to
switch on the laser (35). A laser
line is projected onto the material
you wish to process, providing an
exact guide for the cut.
To switch off : Move the ON/OFF
switch (37) to the "0" position.
Anl_BT_SM_1800_SPK7.indb 46 Anl_BT_SM_1800_SPK7.indb 46
GB

7. Replacing the power cable

Danger!
If the power cable for this equip-
ment is damaged, it must be
replaced by the manufacturer or
its after-sales service or similarly
trained personnel to avoid dan-
ger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power
plug before starting any cleaning
work.
8.1 Cleaning
Keep all safety devices, air
•
vents and the motor housing
free of dirt and dust as far as
possible. Wipe the equipment
with a clean cloth or blow it
with compressed air at low
pressure.
We recommend that you
•
clean the device immediately
each time you have finished
using it.
Clean the equipment regularly
•
with a moist cloth and some
soft soap. Do not use cleaning
agents or solvents; these
could attack the plastic parts
- 46 -
26.07.2018 07:46:52 26.07.2018 07:46:52