Technical Data - EINHELL BT-SM 1800 Originalbetriebsanleitung

used as prescribed it is still im-
possible to eliminate certain re-
sidual risk factors. The following
hazards may arise in connection
with the machine's construction
and design:
Contact with the saw blade in
•
the uncovered saw zone.
Reaching into the running
•
saw blade (cut injuries).
Kick-back of workpieces and
•
parts of workpieces.
Saw blade fracturing.
•
Catapulting of faulty carbide
•
tips from the saw blade.
Damage to hearing if ear-
•
muffs are not used as neces-
sary.
Harmful emissions of wood
•
dust when used in closed
rooms.

4. Technical data

AC motor: ............. 230 V ~ 50Hz
Power: .......................................
... 1500 W S1 / 1800 W S2 5 min.
Idle speed n : ............5000 min
0
Carbide saw blade: ...................
.................ø 210 x ø 30 x 2.8 mm
Number of teeth: ................... 48
Swiveling range: .. -45° / 0°/ +45°
Miter cut to the left: .......0° to 45°
Miter cut to the right: .....0° to 45°
Saw width at 90°: .. 310 x 62 mm
Anl_BT_SM_1800_SPK7.indb 38 Anl_BT_SM_1800_SPK7.indb 38
GB
Saw width at 45°: .. 210 x 62 mm
Saw width at 2 x 45°
(double miter cut left): ...............
............................... 210 x 36 mm
Saw width at 2 x 45°
(double miter cut right): .............
............................... 210 x 20 mm
Weight: ................. approx. 11 kg
Laser class: ............................. 2
Wavelength of laser: .......650 nm
Laser output: ................. ≤ 1 mW
A load factor of S2 5 min (inter-
mittent periodic duty) means
that you may operate the motor
continuously at its nominal power
level (1800 W) for no longer than
the time stipulated on the spe-
cifi cations label (5 minutes ON
period). If you fail to observe this
time limit the motor will overheat.
During the OFF period the motor
will cool again to its starting tem-
perature.
Danger!
Sound and vibration
Sound and vibration values were
-1
measured in accordance with EN
61029.
- 38 -
26.07.2018 07:46:51 26.07.2018 07:46:51