Operation - EINHELL BT-SM 1800 Originalbetriebsanleitung

5.5 Adjusting the miter angle
on the machine head (Fig.
2, 12-13)
Undo the locking screw (21).
•
Hold the machine head (4) by
•
the handle (1).
After pulling the button (33),
•
the machine head can be
tipped infinitely as well as to
several locking points.
Angles to the left: 0-45°
•
Angles to the right: 0-45°
•
Re-tighten the locking screw
•
(21).
5.6 Adjusting the movable
stop rails
(Fig. 1, 10-14)
Caution! This saw is equip-
•
ped with movable stop rails
(34) that are screwed to the
fixed stop rail (11).
For carrying out angle and mi-
•
ter cuts the movable stop rails
must be adjusted to prevent a
collision with the saw blade.
For miter and angle cuts to
•
the left, the left stop rail must
be moved outwards. For angle
cuts to the right, the right stop
rail must be moved outwards.
Undo the locking screws on
the movable stop rails and
pull the rails back so far that
a collision with the saw bla-
de can be ruled out. Prior to
Anl_BT_SM_1800_SPK7.indb 42 Anl_BT_SM_1800_SPK7.indb 42
GB
every cut retighten the locking
screws of the stop rails.
For miter cuts and double mi-
•
ter cuts with the saw head til-
ted to the right, the right stop
rail must be removed com-
pletely. Important! In this case
the maximum permissible
workpiece height is reduced
(see 4. Technical data).
Always fasten the movable
•
stop rails back to the equip-
ment again after you have
completed your work.
The stop rails must always re-
•
main together with the equip-
ment. A removed stop rail will
impair the operational safety
of the equipment.

6. Operation

6.1 Cross cut 90° and
turntable 0° (Fig. 1-3, 11)
For cutting widths up to approx.
100 mm it is possible to fi x the
saw's drag function with the lo-
cking screw for drag guide (24) in
rear position. If the cutting width
exceeds 100 mm, you must en-
sure that the locking screw for
drag guide (24) is slackened and
that the machine head (4) can be
moved.
- 42 -
26.07.2018 07:46:52 26.07.2018 07:46:52