EINHELL BT-SM 1800 Originalbetriebsanleitung Seite 41

the workpiece support (26).
Mount the workpiece support
•
(10) on the fixed saw table
(18) and tighten the appropri-
ate locking screw (26) (Figure
4).
Mount the second workpiece
•
support (10) on the opposite
side of the saw and secure
with the appropriate locking
screw (26).
When the locking screw (21)
•
is loosened, you can tilt the
machine head (4) to the left
by up to 45°.
To ensure that the saw is
•
standing securely, adjust the
adjustable foot (13) by turning
it so that the saw stands in a
horizontal and firm position.
Screw the additional feet (9)
•
to the feet of the fixed saw ta-
ble (18).
Then swing out the stability
•
bar (36) to the rear until it en-
gages.
5.3 Precision adjustment of
the stop for crosscut 90°
(Fig. 7-8)
Fasten the turntable (17) in 0°
•
position.
Undo the locking screw (21)
•
and move the machine head
(4) all the way to the right
using the handle (1).
Anl_BT_SM_1800_SPK7.indb 41 Anl_BT_SM_1800_SPK7.indb 41
GB
Place the 90° angular stop (a)
•
between the blade (7) and the
turntable (17).
Adjust the adjustment screw
•
(29) until the angle between
the blade (7) and the turntab-
le (17) equals 90°.
Finally check the position of
•
the pointer (20) on the scale
(19). If necessary, undo the
pointer (20) with a Philips
screwdriver, set it to the 0°
position on the scale (19) and
retighten the retainer screw.
No stop angle included.
•
5.4 Precision adjustment of
the stop for miter cut 45°
(Fig. 1, 6, 7, 9)
Fasten the turntable (17) in 0°
•
position.
Undo the locking screw (21)
•
and move the machine head
(4) all the way to the left using
the handle (1), until it coinci-
des at 45°.
Place the 45° stop angle (b)
•
between the blade (7) and the
turntable (17).
Adjust the adjustment screw
•
(30) so that the angle bet-
ween the blade (7) and the
turntable (17) equals exactly
45°.
No stop angle included.
•
- 41 -
26.07.2018 07:46:52 26.07.2018 07:46:52