Protection Class - EINHELL BT-SM 1800 Originalbetriebsanleitung

Warning! The adjustable stop rails are secured by hex screws.
To make miter cuts (with the saw head inclined or the turntable set at
an angle), the adjustable stop rails must be fi xed at an outer position.
For 45° crosscuts to the left, the left stop rail must be pushed out-
wards and screwed tight.
For 45° crosscuts to the right, the right-hand stop rail must be pushed
outwards and screwed tight.
To make 90° crosscuts, the adjustable stops rail must be fi xed at the
inner position!
Caution! Do not open this screw!
Protection Class II
Anl_BT_SM_1800_SPK7.indb 34 Anl_BT_SM_1800_SPK7.indb 34
GB
- 34 -
26.07.2018 07:46:51 26.07.2018 07:46:51