EINHELL BT-SM 1800 Originalbetriebsanleitung Seite 45

6.6 Sawdust bag (Fig. 2)
The saw is equipped with a de-
bris bag (22) for sawdust and
chips.
The debris bag (22) can be emp-
tied by means of a zipper at the
bottom (1).
6.7 Changing the saw blade
(Fig. 1, 16-18)
Before changing the saw bla-
•
de: Remove the power plug!
Wear work gloves to prevent
•
injury when changing the saw
blade.
Swing the machine head up-
•
wards (4).
Undo the screw (z) on the co-
•
ver plate (f) of the saw blade.
Pull back the adjustable bla-
•
de guard (6) and at the same
time turn the cover plate to
achieve access to the flange
bolt.
Press the saw shaft lock (5)
•
with one hand while positio-
ning the hexagon key (d) on
the flange bolt (31) with the
other hand. The saw shaft
lock (5) engages after no
more than one rotation.
Now, using a little more force,
•
slacken the flange screw (31)
in the clockwise direction.
Turn the flange screw (31)
•
Anl_BT_SM_1800_SPK7.indb 45 Anl_BT_SM_1800_SPK7.indb 45
GB
right out and remove the ex-
ternal flange (32).
Take the blade (7) off the in-
•
ner flange and pull out down-
wards.
Carefully clean the flange
•
screw (31), outer flange (32)
and inner flange.
Fit and fasten the new saw
•
blade (7) in reverse order.
Important. The cutting angle
•
of the teeth, in other words
the direction of rotation of the
saw blade (7) must coincide
with the direction of the arrow
on the housing.
Check to make sure that all
•
safety devices are properly
mounted and in good working
condition before you begin
working with the saw again.
Important. Every time that you
•
change the saw blade, check
to see that it spins freely in
the table insert(12) in both
perpendicular and 45° angle
settings.
Important. The work to
•
change and align the saw
blade (7) must be carried out
correctly.
6.8 Transport (Fig. 1-3)
Retighten the locking screw
•
(14) to secure the turntable
(17) in place.
- 45 -
26.07.2018 07:46:52 26.07.2018 07:46:52