Before Starting The Equipment; General Information - EINHELL BT-SM 1800 Originalbetriebsanleitung

longed period or is not pro-
perly guided and maintained.
5. Before starting the
equipment
Before you connect the equip-
ment to the mains supply make
sure that the data on the rating
plate are identical to the mains
data.
Warning!
Always pull the power plug
before making adjustments to
the equipment.

5.1 General information

The equipment must be set
•
up where it can stand secure-
ly, i.e. it should be bolted to a
workbench, a universal base
frame or similar.
All covers and safety devices
•
have to be properly fitted
before the equipment is swit-
ched on.
It must be possible for the
•
blade to run freely.
When working with wood that
•
has been processed before,
watch out for foreign bodies
such as nails or screws, etc.
Before you actuate the On/
•
Off switch, make sure that the
saw blade is correctly fitted
Anl_BT_SM_1800_SPK7.indb 40 Anl_BT_SM_1800_SPK7.indb 40
GB
and that the equipment's mo-
ving parts run smoothly.
5.2 Assembling the saw
(Fig. 1-5)
To adjust the turntable (17),
•
loosen the locking screw (14)
by approx. 2 turns, which
frees the turntable (17).
Turn the turntable (17) and
•
scale pointer (15) to the desi-
red angular setting on the dial
(16) and lock into place with
the locking screw (14). The
saw has locking positions at
angles of - 45°, -31.6°, -22.5°,
-15°, 0°, 15°, 22.5°, 31.6° and
45°, at which the turntable
(17) audibly clicks into positi-
on.
To release the saw from its
•
position at the bottom, pull
the fastening bolt (25) out
of the motor mounting while
pressing down lightly on the
machine head (4). Turn the
fastening bolt (25) through
90° before releasing it, so that
the saw remains unlocked.
Swing the machine head (4)
•
up until the release lever (3)
latches into place.
The clamping device (8) can
•
be fitted on the left or right of
the fixed saw table (18).
Undo the locking screws for
•
- 40 -
26.07.2018 07:46:52 26.07.2018 07:46:52