Proper Use; Technical Data - EINHELL BT-MS 250 L Originalbetriebsanleitung

Anleitung_BT_MS_250_L_SPK1:_
Hex wrench (31)
Clamping device (19)
Sawdust bag (14)
Stability bar (32)
Original operating instructions
Safety instructions

4. Proper use

The crosscut saw is designed to crosscut wood and
plastic commensurate with the size of the machine.
The machine is not to be used for cutting fire wood.
The machine is to be used only for its prescribed
purpose.
Any use other than that mentioned is considered to
be a case of misuse. The user/operator and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The machine is to be operated only with suitable saw
blades. It is prohibited to use any type of cutting-off
wheel.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about its potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors. The following risks may arise due to the
machine's design and setup:
Contact with the saw blade in the uncovered saw
zone.
Reaching into the running saw blade (cut
injuries).
Kick-back of workpieces and parts of
workpieces.
Saw blade fracturing.
Catapulting of faulty carbide tips from the saw
blade.
Damage to hearing if essential ear-muffs are not
worn.
Harmful emissions of wood dust when the
machine is used in closed rooms.
30.06.2010 9:32 Uhr Seite 15
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

5. Technical data

Asynchronous motor
Input power
Operating mode
Idle speed n
Carbide saw blade
Number of teeth
Weight
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Laser class
Laser wave length
Laser output
Laser module power supply
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
Vibration emission value a
K uncertainty = 1,5 m/s
230 V ~ 50 Hz
4800 rpm
0
ø250 x ø30 x 3 mm
-45° / 0° / +45°
0° to 45° to the left
max. 120 x 75 mm
max. 75 x 85 mm
85 x 40 mm
2 x 1.5 V Micro (AAA)
89,2 dB(A)
102,2 dB(A)
= 6,116 m/s 2
h
2
GB
1600 W
S1
60
12,3 kg
2
650 nm
≤ 5 mW
3 dB
3 dB
15