Technical Data - EINHELL NEW GENERATION NMS 210 Originalbetriebsanleitung

Anleitung_NMS_210_SPK7:_
GB

5. Technical data

Asynchronous motor
Input power
Operating mode
Idle speed n
0
Carbide saw blade
Number of teeth
Weight
Tilting range
Mitre cuts
Sawing width at 90°
Sawing width at 45°
Sawing width at 2 x 45°
(double mitre cuts)
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
Vibration emission value a
= 2,14 m/s
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
12
12.07.2010 7:39 Uhr Seite 12
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
230 V ~ 50 Hz
order.
1200 W
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
S1
Do not overload the appliance.
5000 rpm
Have the appliance serviced whenever
necessary.
ø210 x ø30 x 2,5 mm
Switch the appliance off when it is not in use.
24
Wear protective gloves.
8,8 kg
Residual risks
-45° / 0° / +45°
Even if you use this electric power tool in
0° to 45° to the left
accordance with instructions, certain residual
max. 120 x 60 mm
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
max. 80 x 65 mm
construction and layout:
1. Lung damage if no suitable protective dust mask
80 x 35 mm
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.
6. Before putting the machine into
94,2 dB(A)
operation
3 dB
107,2 dB(A)
The machine has to be set up in a stable
3 dB position, i.e. it has to be bolted to a workbench, a
universal stand or the like.
All the covers and safety devices have to be
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
2
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
6.1 Setting up the saw (Fig. 12)
Screw the additional stability bar (32) to the back
of the machine.
6.2 Adjusting the saw (Fig. 1/2)
To adjust the turntable (8), loosen the locking
grip (10) by approx. 2 turns, which frees the
turntable (8).