Handicare SIMPLICITY Installationsanleitung Seite 6

Track assembly
Figure 11
Figure 12
6 HANDICARE SIMPLICITY INSTALLATION MANUAL
10 Position the feet in the following way
(Figure 11):
a The top foot should be positioned on the
last tread.
b The middle foot should be positioned
immediately next to the spliced joint. If the
top section is longer than the bottom then
the foot should be ABOVE the spliced joint,
if not, then the foot should be BELOW the
spliced joint.
c The bottom foot should be positioned on
the first tread.
11 Loosely tighten the feet to stop them from
moving. The feet will help to stop the track
from moving on the stairs while the next
steps are performed.
Note: If the stairlift is being fitted to a staircase
with open bannisters on the bannister side
they must be covered with a solid sheet
material for safety.
12 If the power supply is:
a At the top of the track:
• Feed the long power cable with the push
terminals from the power supply through
the large cavity in the assembled track.
b At the bottom of the track:
• Bring the long power cable with the push
terminals from the power supply to the
bottom of the track.
13 Slide the track up the stairs and position it
centrally to give you sufficient room to work
comfortably at the bottom of the stairs.
14 Connect the positive push terminal (WHITE
CABLE) to the red push terminal attached
to the busbar (Figure 12).
15 Connect the negative push terminal (BLACK
CABLE) to the push terminal from the track.
16 Fit the bottom end stop and final limit stop
to the bottom of the track only (Figure 13).