Handicare SIMPLICITY Installationsanleitung Seite 23

c Check that the lift stopped within 20mm of
the point where the button was released.
5 Check the track and all stanchions/feet are
secure.
Slide Track installations only
1 Using the handset:
a Drive the lift to the top of the stairs.
b Depress the down button and keep
it depressed.
c Observe the function of the lift.
The lift should:
i Drive down the stairs at half speed
moving with the Slide Track.
ii Depending upon the length of the track:
• If the lift does not reach the end of the
track before the Slide Track has completed
its travel then the Slide Track will stop whilst
the lift will continue to the end of the track
and ramp up to normal speed.
• If the lift does reach the end of the track
before the Slide Track has completed its
travel then the stairlift will stop and the
Slide Track lift will continue to the end
of its travel.
d Depress the up button and keep
it depressed.
e Observe the function of the lift.
The lift should:
i Drive up the stairs.
ii Depending upon the length of the track:
• If the lift does not reach the end of the
track before the Slide Track has completed
its travel then the Slide Track will stop
whilst the lift will continue to the end of
the track and ramp up to normal speed.
• If the lift does reach the end of the track
before the Slide Track has completed its
travel then the stairlift will stop and the Slide
Track will continue to the end of its travel.
2 Sit on the stairlift:
a Drive the lift to the top of the stairs.
b Push the toggle switch in the down direction
and hold it in that position.
c Observe the function of the lift.
The lift should:
i Drive down the stairs.
ii Depending upon the length of the track:
• If the lift does not reach the end of the track
before the Slide Track has completed its
travel then the Slide Track will stop whilst the
lift will continue to the end of the track and
ramp up to normal speed.
• If the lift does reach the end of the track
before the Slide Track has completed
its travel then the stairlift will stop and
the Slide Track will continue to the end
of its travel.
d Push the toggle switch in the up direction
and hold it in that position.
e Observe the function of the lift.
The lift should:
i Drive up the stairs.
ii Depending upon the length of the track:
• If the lift does not reach the end of the track
before the Slide Track has completed its
travel then the Slide Track will stop whilst the
lift will continue to the end of the track and
ramp up to normal speed.
• If the lift does reach the end of the track
before the Slide Track has completed
its travel then the stairlift will stop and
the Slide Track will continue to the end
of its travel.
3 Turn off the power supply to the charge
contacts.
4 Repeat steps 1 and 2 above.
5 Turn the power supply back on.
HANDICARE SIMPLICITY INSTALLATION MANUAL 23
Testing