Ottobock 3S80 Gebrauchsanweisung Seite 30

Situation
Lower leg swings through
too far
Lower leg does not swing
through sufficiently
Lower leg impact too hard
on the extension stop
Lower leg does not reach
full extension before heel
strike
6 Use
CAUTION
Overheating of the hydraulics due to excessive strain
Burns, injuries caused by falling due to changes in functionality and dam­
age to prosthesis components
► Do not touch overheated prosthesis components.
► In case of changes in functionality, stop all activities and allow the over­
heated prosthesis components to cool down.
► In case of changes in functionality, reduce strain on the prosthesis
component in order to allow cooling.
► In case of overheating or changes in functionality, have the prosthesis
component inspected for damage by a service centre authorised by the
manufacturer.
► Inform the patient.
NOTICE
Mechanical overload
Impaired functionality due to mechanical damage
► Check the product for damage prior to each use.
► Do not use the product if its functionality has been impaired.
► Take suitable measures if required (e.g. repair, replacement, inspec­
tion by the manufacturer's customer service etc.).
► Inform the patient.
INFORMATION
Secure Standing
The prosthetic joint is equipped with a lever to secure it when standing
(see fig. 3).
30
Measure
Increase damping
Reduce damping
Increase damping
Reduce damping
Adjustment
Turn flexion valve to the
right (+)
Turn flexion valve to the left
(–)
Turn extension valve to the
right (+)
Turn extension valve to the
left (–)