Cleaning And Servicing; Cleaning The Base Unit - Bosch MUM58 Serie Gebrauchsanleitung

en

Cleaning and servicing

Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous­feed shredder
and empty feed tube.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in
an anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise direc­
tion and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. J).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem­
bled blender only and with the lid attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a
max. 0,5 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep­frozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Fig. K:
■ Press the release button and
move the swivel arm to
position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle
on mark on the base unit) and turn all the
way in an anti­clockwise direction.
24
■ Add ingredients.
Maximum amount of liquid = 1.25 litres;
maximum amount of frothing or hot
liquids = 0.5 litres;
Optimal processing capacity –
solids = 50­100 g;
■ Attach the cover and turn anti­clockwise
all the way into the blender handle. The
cover must be locked in position.
■ Set the rotary switch to the desired
setting.
Adding more ingredients
Fig. K-8:
■ Switch off the appliance with the rotary
switch.
■ Remove the lid and add ingredients
or
■ remove the funnel and gradually add solid
ingredients through the refill opening
or
■ pour liquid ingredients through the funnel.
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the blender in a clockwise direc­
tion and remove.
Tip: It is recommended to clean the blender
immediately after use.
Cleaning and servicing
The attachments and accessories used
must be thoroughly cleaned after each use.
Attention!
Do not use abrasive cleaning agents.
Surfaces may be damaged.

Cleaning the base unit

W Danger of electric shock!
Never immerse the base unit in water or
place under running water. Do not use a
steam cleaner.
■ Remove mains plug.
■ Wipe the base unit and drive cover with
a damp cloth. If required, use a little
detergent.
■ Then dry the base unit.