Bosch MUM58 Serie Gebrauchsanleitung Seite 23

Warning!
The continuous­feed shredder must be com­
pletely assembled before use. Never assem­
ble the continuous­feed shredder on the base
unit. Operate the continuous­feed shredder in
the indicated operating position only.
Predetermined breaking point
Fig. G:
The built­in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the con­
tinuous­feed shredder breaks. However, the
drive shaft can easily be replaced. A new
disc holder with drive shaft is available from
customer service.
Potato fritter disc
For grating raw potatoes for
rostis and potato fritters, for cutting
fruit and vegetables into thick slices.
Grating: Process at setting 7.
Cutting: Process at setting 5.
Reversible shredding disc –
coarse / fine
for shredding vegetables, fruit and cheese,
except for hard cheese (e.g. Parmesan).
Processing at setting 3 or 4.
Designation on the reversible shredding
disc:
"2" for the coarse shredding side
"4" for the fine shredding side
Warning!
The reversible shredding disc is not suitable
for shredding nuts. Shred soft cheese with
the coarse side only at setting 7.
Grating disc – medium-fine
for grating raw potatoes, hard
cheese (e.g. Parmesan), cooled chocolate
and nuts.
Process at setting 7.
Warning!
The grating disc is not suitable for grating
soft cheese and cheese slices.
Grating disc coarse
for grating raw potatoes, e.g. for
potato pancakes or dumplings.
Process at setting 7.
Asian vegetable disc
slices fruit and vegetables into fine
strips for Asian vegetable dishes.
Process at setting 7.
Working with the continuous-feed
shredder
Fig. H:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti­clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the
drive of the continuous­feed shredder
(Fig. H-5a).
■ Hold disc holder at the lower end, ensur­
ing that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. H-6a).
In the case of reversible discs, ensure
that the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. H-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous­feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. H-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Operation en
23