Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.31 Display - Contrast
Press
7.32 Set Password
Press
7.33 Operating Lock
Only the ON/OFF (start and stop) buttons
In order to change the desired set value, the lock function must be switched off [OFF],
than you can return into the main menu and the set pressure can be changed.
Press
7.34 Setting Default Values
Press
Attention
To leave the submenu press the
Downloaded from
www.Manualslib.com
DISP. CONTRAST
50 %
on the Hydrovar-Smart to change to
SET PASSWORT
0066
on the Hydrovar-Smart to change to
LOCK FUNCTION
OFF
on the Hydrovar-Smart to change to
S U B M E N U
DEFAULT VALUES
7.34.1 Default Values Europe
DEFAULT EUROPE
+
(e.g.: maximum frequency 50 Hz, display unit = bar, Analog out 1 =
on the Hydrovar-Smart to change to
7.34.2 Default Values USA
DEFAULT USA
+
(e.g.: max. frequency 60 Hz, display unit = psi, Analog out 1 = Frequency)
After reloading the default settings the display is flashing, to deactivate the
flashing press the
manuals search engine
Can be adjusted between 10...100%. For improved
clarity of the display, depending on the installation
position.
The pre-set password can be changed if necessary.
When [ON] is activated, it is not possible to make
any changes in the main menu.
and
are active.
Press
for about 3 seconds to enter the submenu
and the display changes to
Load the DEFAULT – PARAMETERS for Europe
Press buttons
+
Frequency)
Load the DEFAULT – PARAMETER for the USA
Press buttons
+
until you reach the parameter "SAVE"
longer than 3 sec. and change to
39
for approx. 5 seconds.
for approx. 5 seconds
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
