Submenu For Manual Test Run; Activate Manual Test Run; Test Frequency; Submenu - Error - Xylem HYDROVAR Smart Bedienungsanleitung

7.28 Submenu for manual test run

The function and operation of the started manual test run is similar to the automatic
test run
Press
Press
To leave the submenu press the
Press

7.29 Submenu - Error

"disabled" or "0 bar" is shown on the display.
An adjusted value >0 has to be reached till the programmed "DELAY TIME".
Doesn't this value be reached; the failure "VAL. RANGE CONTR." will be indicated and
the pump stops.
Press
Downloaded from www.Manualslib.com
S U B M E N U
TEST RUN man.

7.28.1 Activate manual test run

TEST RUN man.
+
on the Hydrovar-Smart to change to

7.28.2 Test Frequency

TEST-FREQUENCY
30.0 Hz
on the Hydrovar-Smart to change to
S U B M E N U
TEST RUN man.
on the Hydrovar-Smart to change to
S U B ME N U
ERRORS

7.29.1 Conveyor Limit

CONVEYOR-LIMIT
disabled
on the Hydrovar-Smart to change to
manuals search engine
Press for about 3 seconds to enter the submenu
and the display changes to
By simultaneously pressing
be released.
Frequency for manual and automatic test run.
Can be set from 6.0 Hz up to 70,0 Hz
longer than 3 sec. to change to
Press for about 3 seconds to enter the submenu
and the display changes to
Disabled or adjustable between 0.00...SENSOR
RANGE. To disable the conveyor limit, press
37
+ a test run will
till