Xylem HYDROVAR Smart Bedienungsanleitung Seite 18

2.
Press the
!! The following displays of the main menu are valid for all selected Modes !!
3.
AUTO-START ON starts the pump automatically after a failure of the power supply.
If AUTO-START is OFF, the Hydrovar-Smart has to be restarted by pressing the buttons
(OFF) and then
If the AUTO-START is OFF, the unit will not start again in cases of a power supply failure or
disconnection. After restarting the following message is shown:
3.1
To restart the unit, press at first the
Press
4.
Press the
5.
Press the
6.
Press the
7.
Press the
8.
Press the
Downloaded from www.Manualslib.com
MANUAL LOCAL
X.X Hz X.XX BAR
If several pumps are connected via the RS-485 interface, you have to set this
parameter on each pump!
button on the Hydrovar-Smart to change to
AUTO - START
ON
(ON) after a power supply failure.
NO AUTOSTART
disable inverter
and the display changes to
Note: All errors are only readable in English language
E R R O R 1
.........................
button to change to
E R R O R 2
.........................
button to change to
E R R O R 3
.........................
button to change to
E R R O R 4
.........................
button to change to
E R R O R 5
.........................
button to change to
manuals search engine
Set the desired output frequency with either
and then briefly press the
Select (ON) with the
and then the
Here, there is shown the last error
Shows the error before the last error
Shows the error before error 2
Shows the error before error 3
Shows the error before error 4
18
-button.
button or (OFF) with
button for the start.
or
.