Xylem HYDROVAR Smart Bedienungsanleitung Seite 19

9.
Press the
Note: All changes have to be saved, that they will not be lost in case of shut off
of the power supply !!
10.
11.
These parameters can also be set during operation; To do so, briefly press the button
and repeat steps 1 – 10.
Note: Often shown displays:
12.
To start the Hydrovar-Smart, connect these terminals by closing the external release contact
or by using a short-circuit connection!
Downloaded from www.Manualslib.com
TOTAL RUN TIME
0000:00
button to change to
SAVE ???
+
SAVE ???
SAVED
INVERTER LOCKED
enable inverter
manuals search engine
Runtime of the motor.
This time can be reset together with the
Operating hours.
Simultaneously press buttons
appears on the display. After five seconds the
display jumps back to the 1
This message appears when the connection of
terminal X1/4-X1/5 is open (external release contact).
19
and until...:
st display.