Renishaw PH20 Installations- Und Bedienungsanleitung Seite 17

PH20 installation and user's guide
www.renishaw.com
Manually mounting / removing the stylus modules to / from PH20
It is not recommended to manually remove and refit a probe module to PH20. If it is absolutely neccessary to manually remove the probe
module from PH20 it should only be done in certain orientations. Please see the image below.
To fit the probe module and stylus onto the probe body, carry out the following procedure:
1. Visually examine the mating faces of both the probe module and the probe head for cleanliness; where necessary, clean the mating
surfaces using the CK200 cleaning kit (supplied).
2. Align the probe module to the PH20 using the reverse of the method used to remove it manually. Ensure the three alignment marks on
both the probe module and probe body are correctly aligned, allow the probe module to engage the probe body under magnetic force.
Issued 03 2019
Downloaded from www.Manualslib.com manuals search engine
17