Renishaw PH20 Installations- Und Bedienungsanleitung Seite 16

PH20 installation and user's guide
www.renishaw.com
Trigger force options
The standard force probe module is suitable for most applications (when used with the recommended stylus range), but sometimes the
effects of stylus length and mass, combined with machine acceleration and vibration, can cause the probe to false trigger (these are referred
to as 'false triggers'﴿.
To allow the PH20 to be used on co-ordinate measuring machines where acceleration forces or vibration would otherwise result in spurious
triggers, a choice of higher force probe modules is available. A low force probe module is also available for measurement of delicate
materials. Refer to the applications guide later in this document for information on how to select the correct probe module for your
application.
The type of probe modules supplied with your probe will be clearly marked on each probe module's front ring. The probe modules also carry
a colour-coded front cap as follows:
Low force (LF) probe module (green cap)
Standard force (SF) probe module (black cap)
Medium force (MF) probe module (grey cap)
6-way (6W) probe module (blue cap)
Extension module 1 standard force (EM1 STD) (black cap)
Extension module 2 standard force (EM2 STD) (black cap)
NOTE: The extended force module is not suitable for use with the PH20 system.
TP20 module kits
The following TP20 probe module kits are available from your supplier for use with PH20:
TP20 probe module kit (probe module only)
Low force probe module
Standard force probe module
Medium force probe module
6-way probe module
EM1 STD probe module
EM2 STD probe module
EM1 STD and EM2 STD probe modules
Issued 03 2019
Downloaded from www.Manualslib.com manuals search engine
Part number
A-1371-0392
A-1371-0270
A-1371-0271
A-1371-0419
A-1371-0430
A-1371-0431
A-1371-0432
16