Coupling/Uncoupling The Attachment - Rapid MONTA M 141 Betriebsanleitung

Start-up
2. Adjust the plate to summer operation
(Fig. 56/1) or winter operation (Fig. 56/2).
3. Tighten the screws with a hexagon socket
wrench.
Changing over the flap for summer/winter
operation
Fig. 57: Changing over the flap for summer/winter
operation
4. Set the flap for summer/winter operation to
the position for summer operation
(Fig. 57/1) or winter operation (Fig. 57/2)
with a slotted screw driver.
36 Single-axle walk-behind tractor Rapid MONTA M 141/M 161
4.7 Coupling/uncoupling the
attachment
Protective equipment:
n Protective gloves
n Protective footwear
Pre-requisites:
n The single-axle walk-behind tractor is
switched off.
n The connection flange of the single-axle
walk-behind tractor and the attachment are
clear of dirt.
n The gearing of the PTO is greased.
n The connection flange is greased.
Coupling
WARNING!
Risk of injury from improper coupling
and uncoupling!
– Make sure that no one is in the danger
zone when coupling and uncoupling.
– Only connect the attachment to the
single-axle walk-behind tractor when
the engine is switched off.
– Make sure that the latch pin is
engaged and the attachment is con-
nected to the single-axle walk-behind
tractor.
Fig. 58: Locking lever at connection flange
1. Open the locking lever (Fig. 58/1).
2. Slide the attachment into the connection
flange.
3. Close the locking lever (Fig. 58/1).
20.04.2018