Password; Sd Cycle; Reset; About - SecaCam pro Bedienungsanleitung

selected character backward or forward and with the up and down arrows
you can change the letter. The name can be up to 12 characters long.
5.15

Password

After selecting "ON" enter a six-digit PIN to protect your camera against unau-
thorized access. With the up and down arrow button you change the setting,
with the left and right button you move one position forward or backward.
Confirm the settings with „OK". Choose a code that you can remember well,
and/or write this code down, e.g. on the camera box.
Note: Please use the password option very carefully. If you forget the
selected PIN, the camera is also useless for you. In this case please contact
our customer service.
5.16

SD Cycle

By activating this menu setting (switch to „ON") you allow new recordings to
be shot even if the memory card is full. Please be aware that in the "Cycle
Recording" mode the oldest recordings will be overwritten by new record-
ings. This option is especially useful if you use the SECACAM Pro for property
protection, as it helps to prevent the camera from stopping to further record
when the memory card is full.
5.17

Reset

Press "Yes" to reset the camera settings to the default values and confirm
the selection by pressing the "OK" button. The date and time setting is not
affected. Of course your files aren't erased as well.
5.18

About

Shows the firmware version installed on the camera. The SECACAM Pro is
continually being developed. Please visit www.secacam.com, service@seca-
cam.com and check if a new firmware is available.
50
5. Menu