Remote Control; Battery Type; Date/Time; Language - SecaCam pro Bedienungsanleitung

5. Menu
„time lapse" and choose 10 seconds. The SECACAM Pro will take a
photo every 10 seconds in the predefi ned time interval.
Outside the selected time interval, the camera is not triggered and will not
record any photos or videos.
5.10

Remote Control

The camera can be turned on and off using a remote control at up to three
metres. In order for the remote control to work, the camera must be switched
ON in the inside of the camera. Then, when you press the ON button on the
remote control, a green light on your camera will signal that the camera is
operating. Then, when you press the OFF button on the remote control, the
camera LED will fl ash red, signalling that it is turning off.
5.11

Battery type

The SECACAM Pro can also be used with rechargeable batteries type AA
1.5V. In order to get a correct battery display you can choose which battery
type you are using in this menu. (Generally rechargeable batteries have a
higher capacity but a lower voltage than disposable batteries.)
5.12

Date/Time

Before using the SECACAM Pro for the fi rst time it is necessary to set the time
and date. Use the up and down arrow buttons to change the setting, with the
right and left arrow button you move one position forward or backward. Con-
fi rm the settings with „OK". The date and time will now appear in every shot to
document the exact second a photo has been recorded.
5.13

Language

Choose the desired menu language. In Europe "German" is per activated by
default. You can also switch the menu to Spanish, French or Italian.
5.14

Camera Name

You have the option to name your camera which is then displayed in the cap-
tion of all photos taken. When your camera is switched to the SETUP option
and you access the menu settings, there is a submenu option for 'Camera
Name'. Using the left and right arrow keys, you can move the position of the
49