Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.2. Transporting the Mask
Aligner
Special safety precautions must be taken to protect
the Mask Aligner from damage before it can be
transported.
The machine must be transported and installed by a
SUSS MicroTec service technician or person
authorized by SUSS MicroTec.
Users who transport the machine without a SUSS
MicroTec service technician or a person authorized
by SUSS MicroTec do so at their own risk.
2.2.1. Warranty and Restrictions
Devices are delivered with a 12-month warranty.
This warranty also applies to material included with
the machine and working quality of the machine.
This warranty can vary in individual cases due to
different national laws in other parts of the world, for
example. The warranty for this machine is included
in the attached documents.
The warranty is limited to:
•
Equipment and material unpacked and installed
by a SUSS MicroTec service technician
•
Equipment and material used according to the
instructions in the operating manual
•
Equipment and material that is maintained and
handled carefully and as indicated in the
instructions
This warranty does not cover:
•
Damage caused while transporting the machine
(damage must be shown to the shipping
company)
•
All parts subject to normal wear and tear (e.g.
exposure lamps, exposure masks, microscope
lights, etc.)
2.2.2. Receiving and Unloading
the Machine
•
Persons must never stand under suspended
loads!
•
Check the number of shipping containers
•
Observe the transport instructions on the
SAFETY-INST MJB4 Rev09 17-03 INSTALLATION AND TRANSPORT
INSTALLATION AND TRANSPORT
shipping container
•
Never tilt or hit shipping containers
•
Check shipping packaging for traces of damage
due to shipping
•
(tilt indicator, impact indicator)
•
Inform SUSS MicroTec and the shipper
immediately if any damage is detected
•
If necessary, the machine must be stored in a
dry, heated room
2.2.3. Opening the Shipping Con-
tainers
•
If shipping damage is suspected, do not open
containers until a SUSS MicroTec service
technician or a person authorized by SUSS
MicroTec is present. If clear damage is detected,
call in an average adjuster or an insurance claims
adjuster.
•
Unpack the machine only in the presence of a
SUSS MicroTec service technician or person
authorized by SUSS MicroTec.
•
Do not lift the machine from the pallet until the
sides of the container and machine fixings have
been removed.
•
Check all accessory parts against the packing
slip.
•
Store packing material for reshipment or return
shipment.
•
If you would like to return packaging material, you
must make arrangements with the appropriate
SUSS MicroTec representative.
2.2.4. Transport without a Pallet
•
The relevant safety and shipping conditions in
force must be observed for transport
•
Persons must never stand under suspended
loads!
•
Leave the cover above the machine until the
machine has reached the intended location
•
Do not, under any circumstances, loosen the
machine's transport locks before the machine
has reached the intended location
•
Lifting the machine by placing a forklift directly
beneath the bare base plate causes a serious
slip hazard
•
Avoid tilting the machine beyond 10° when
transporting the it on wheels over a ramp.
- Original Documentation -
2
15
Werbung
Kapitel
Inhaltsverzeichnis
