Vitek VT-1557 SR Betriebsanweisung Seite 6

ENGLISH
Programming of cooking modes
You can program cooking modes yourself.
• Insert the plug into the socket
• Switch on the Steam cooker, by pressing
the (15) button, the LCD-display (14) will
light up and you will hear a sound signal.
• Press and hold the (17) button for 3 sec-
onds, the "Р1:00" symbols will start flashing
on the LCD-display. Set the desired cooking
time, using the (18) buttons and press the
(19) button to store the entered value.
• To set the cooking time for the second
mode press the (17) button till the "Р2:00"
symbols appears on the LCD-display. Set
the desired cooking time, using the (18)
buttons and press the (19) button to store
the entered value.
Timer setting
You can set delay time for the Steam cooker
to switch on.
• Press the (16) button. The (
"00:00" symbols will appear on the LCD-
display.
• Use the (18) buttons to set the delay
time for the Steam cooker to switch on.
Minimal delay time is 5 minutes, maxi-
mal 23 hours 55 minutes, setting step is 5
minutes. Press the (19) button to confirm
the preset time.
• Use the (15) button to select the desired
operating mode and then press the (19.)
button again.
• The timer symbol, operating mode sym-
bol and time symbol (time in which the
cooking process will start) will appear on
the LCD-display.
• After cooking is finished you will hear a
sound signal and the Steam cooker will
switch to the 20 minute-heating mode
automatically. (The (
flashing on the LCD-display).
• After heating is finished you will hear 5
sound signals, in a minute two sound sig-
nals will be heard and the Steam cooker
will switch off.
1557.indd 6 1557.indd 6
• In the standby mode, you can switch off
the timer by pressing the (16) button.
Automatic switch off
If you have not used the Steam cooker for a
minute it will switch off automatically. Before
switching off you will hear two sound sig-
nals. You can stop cooking process during
operation, by pressing the (19) button, and
pressing the (15) button will switch off the
Steam cooker.
No water indication
If water level in the water tank (10) is lower
than the MIN mark, you will hear a sound
signal and the (
ing on the LCD-display.
Fill the water tank (10) with cold water to the
МАХ mark.
You can fill the water tank with water in two
ways: - through the fill port (9) (Pic. 1) or di-
) and the rectly in the water tank (Pic. 2).
ATTENTION!
• During operation do not touch the Lid or
the steam bowls – they are very hot.
• To avoid getting burns use pot holders
when removing the Lid and the steam
bowls. Slowly raise the Lid up to release
steam, hold the Lid over the steam bowl to
drain water.
• If you want to check on the cooking
progress, use a utensil with a long han-
dle.
• Remember that water inside the water
tank can be hot when all the other compo-
nents are cooled down.
• Do not use the Steam cooker without the
tray, the steam bowls or the Lid.
TIPS
) symbol will be
• Cook meat, fish and seafood till it is
cooked completely.
• Always use only defrost products, exclud-
ing vegetables, fish and seafood.
• If you use several steam bowls at a time,
put meat, chicken or fish in the lower bowl
6
) symbol will be flash-
14.02.2008 9:15:34 14.02.2008 9:15:34