Vitek VT-1557 SR Betriebsanweisung Seite 5

• Set the steam sprayer (7).
• Set the mesh filter (11) in the special re-
cess in the water tank (10).
• Fill the water tank (10) with cold water up
to the МАХ mark.
• You can fill the water tank with water in two
ways: - through the fill port (9) (Pic. 1) or
directly in the water tank (Pic. 2).
• If while cooking you will find that there
is not enough water you can add water
through the fill port, (9), without removing
the steam bowls (Pic. 1).
Use filtered water; it has lower hardness,
and it will allow reducing scaling on the heat-
ing element. Do not exceed the MAX mark
while filling the water tank with water.
Warning
- Do not add any salt, pepper, seasonings,
herbs, wine, sauces or other liquids to the
water tank. It may lead to damages of the
unit.
- Change water for every usage of the unit.
• Place the tray for the condensate collec-
tion (6) on the water tank (10) and make
sure that it is set properly.
• Set one or more steam bowls (1-2-3) on
the tray.
• Close the steam bowl with the Lid (5).
• Insert the plug into the socket, a sound
signal will be heard and the LCD-display
will light up; the Steam cooker is ready to
operate within 45 minutes.
Note:
if no actions are performed during 1
minute two sound signals will be heard
and the Steam cooker will switch off.
• Switch on the Steam cooker by pressing
the (15) button, the LCD-display (14) will
light up and you will hear a sound signal.
• Use the auto cooking mode selection
button (17) to select one of the operat-
ing modes: cooking eggs, fish, vegeta-
bles, meat, chicken, rice, heating mode,
1557.indd 5 1557.indd 5
and one of the two programmed cooking
modes "Р1" and "Р2". The corresponding
indication of the product, cooking time
and heating time will light up on the LCD-
display (17).
• After selecting one of the auto cooking
modes you can change the preset cook-
ing time, using the (18) buttons.
• Press the (19) button to start cooking/
heating products, the (
) symbol will be flashing on the LCD-dis-
play.
• After the cooking time is finished, two
sound signals will be heard and the Steam
cooker will switch to the heating mode,
heating time is 20 minutes (the (
) symbol will be flashing on the LCD-dis-
play.
• After heating is finished you will hear 5
sound signals, and the Steam cooker will
switch to the heating mode, in a minute
two sound signals will be heard and the
Steam cooker will switch off.
Note:
in the heating mode you can change
heating time using the (18) buttons.
• To stop cooking or heating, press the (19)
button, the (
be on constantly.
• Press the (15) button to switch off the unit,
or wait till it switches off automatically
WARMING-UP PRODUCTS
• Use the (17) button to select the heating
mode, the (
buttons to set the necessary heating time
from 1 to 99 minutes, press the (19) but-
ton to switch on the unit.
• After heating is finished you will hear 5
sound signals, in a minute two sound sig-
nals will be heard and the Steam cooker
will switch off.
5
ENGLISH
) or (
) or ( ) symbols will
) symbol, use the (18)
14.02.2008 9:15:34 14.02.2008 9:15:34