Initial Startup - Kärcher HDS 8/20 De Handbuch

Motor oil indicator light
38
Manual start device
39
Air filter
40
Overview of HDS 8/20 G
See graphics page for illustration
Illustration B
Protector
1
High-pressure nozzle
2
EASY!Lock spray lance
3
EASY!Force high-pressure gun
4
Safety latch
5
Trigger
6
Unlocking lever
7
EASY!Lock high-pressure hose
8
Ignition electrode
9
Burner sight glass
10
Temperature controller
11
Booster heater
12
Fuel filter
13
Parking brake
14
High-pressure gun storage compartment
15
Electrical box
16
Storage hook for high-pressure hose
17
Air filter
18
Water inlet
19
Motor oil drain screw
20
Water filter
21
Water outlet / high-pressure connection EASY!
22
Lock
Retaining clip
23
Hose piece
24
Sieve in the safety block
25
Pressure relief valve
26
Flow monitor
27
High-pressure pump oil level indicator
28
Fuel tank cap with filter
29
Fuel tank
30
Fuel pre-filter
31
Level switch
32
Top cover
33
Type plate
34
Motor switch
35
Manual start device
36
Fuel cock
37
18
Choke
38
HDS 8/20 De control elements
 Temperature controller
Illustration C
 Motor electrical starter
Illustration D
Motor oil indicator light
1
Motor switch
2
HDS 8/20 G control elements
 Temperature controller
Illustration C
 Motor switch
Illustration E
Motor switch
1
 Choke / fuel cock
Illustration F
Choke
1
Fuel cock
2
WARNING
Damaged components
Risk of injury
Check that the device, accessories, supply lines and
connections are in perfect condition. If the condition is
not perfect, you may not use the device.
Check the oil level in the high-pressure pump
ATTENTION
Milky oil
Device damage
If the oil is milky, inform authorized Customer Service
immediately.
1. Place the device on a flat and level surface.
2. Check the high-pressure pump oil level at the oil lev-
el display.
The oil level must be in the middle of the oil level in-
dication.
3. Top up the oil if necessary.
Starting up the motor
1. Before initial startup of the motor, read the original
instructions for the motor and observe the safety in-
structions.
Check the motor oil level
1. Check the oil level in the motor.
Do not start up the device if the oil level is below the
"MIN" mark.
2. Top up the oil if necessary.
Topping up with fuel - HDS 8/20 De
ATTENTION
Unsuitable fuel
Risk of explosion
Only fill the fuel tank with diesel oil or light heating oil.
Operation with biodiesel according to EN 14214 (above
an exterior temperature of 6 °C) is possible.
Do not use unsuitable fuels, e.g. petrol.
ATTENTION
Operation with an empty fuel tank
Destruction of the fuel pump
Never operate the device with an empty fuel tank.
English

Initial startup