Tube Connection; Electrical Connections; Power Supply - ECOLAB Elados EMP E60 serie Kurz- Betriebsanleitung

Tube connection

4.2

Electrical connections

4.2.1

Power supply

EMP KKS & EMP II
L1
PE
*
N
Assembly see Fig. 2, pos. 13.
EMP III & EMP IV
EMP III
EMP III assembly see Fig. 3, Pos. 15.
EMP IV assembly see Fig. 3, Pos. 15
1 Conduit
1
2 Union nut
3 Insert component
2
4 O-ring
3 Trim the tube (pos. 1) to the precise length.
n
n Push union nut (pos. 2) over tube.
n Weld or glue insert (pos. 3) to the pipe.
4
n Place O-ring (pos. 4) into groove of suction/pressure valve.
n Tighten up union nut.
L1 Mains / external conductor
PE Protective earth wire
N Neutral wire
* not assigned
1
EMP IV
1
2
3
13
Device installation
1 Powerline
Connecting lead to control
2
PCB (in the pump housing)
Connecting lead to the start-up
3 electronic system
(in terminal box lid)
MAN033535 Rev. 06-04.2020