HBM U10M Montageanleitung Seite 26

26
Template: Bridge Sensor
Parameter
Transducer electrical
signal type
Minimum force/weight
Maximum force/
weight
Minimum electrical
value
Maximum electrical
value
Mapping method
Bridge type
Impedance of each
bridge element
Response time
Excitation level
(nominal)
Excitation level
(minimum)
Excitation level
(maximum)
Calibration date
Calibration initials
Calibration period
(days)
Measurement location
ID
1)
Typical values for an HBM U10M 25 kN type force transducer
The user can also write other templates, such as the "Signal Conditioning"
template.
HBM
1)
Value Unit
Bridge sen-
sor
0.000 N
25,000k N
0.00000m V/V
2.08123m V/V
Linear
Full bridge
350.0 Ohm
1.0000000 sec
u
5.0 V
0.5 V
12.0 V
1-Jan-2005
HBM
730 days
0
Rights
level
ID
CAL The physical measurand and unit are
defined when the template is created,
CAL
after which they cannot be changed.
The difference between these values
CAL
is the sensitivity according to the
HBM manufacturing certificate or
CAL
from calibration.
This entry cannot be changed.
ID Bridge type.
For HBM's SG-based transducers,
the bridge type is always full bridge.
ID Input resistance according to the
HBM data sheet
ID Not relevant to HBM transducers.
ID Nominal (rated) excitation voltage ac-
cording to the HBM data sheet
ID Lower limit for the operating range of
the excitation voltage according to
the HBM data sheet.
ID Upper limit for the operating range of
the excitation voltage according to
the HBM data sheet.
CAL Date the manufacturing certificate
was created at HBM (or date of last
calibration or entry of TEDS data).
Format: day-month-year.
CAL Initials of the calibrator or calibration
laboratory concerned (max. three
characters).
CAL Time before recalibration, calculated
from the date specified under Calibra-
tion Date.
USR Identification number for the measur-
ing point (assigned by the user). Pos-
sible values: 0 to 2047 (numbers
only). The HBM Channel Comment
template is also available as a sup-
plement.
U10M, U10S
Explanation
A1385−6.0 en/de/fr