General Application Instructions - HBM U10M Montageanleitung

U10M, U10S
Fig 1.2: U10M without force application bolt (left) and with mounted force ap-
plication bolt (right); both pictures with foot adapter
2

General application instructions

The force transducers are suitable for measuring tensile and compressive
forces. Because they provide highly accurate static and dynamic force mea-
surements, they must be handled very carefully. Particular care must be taken
when transporting and installing the devices. Dropping or knocking the trans-
ducers may cause permanent damage.
Force transducers U10M have a metric internal thread and force transducers
U10S have an internal thread to UN/UNF standard.
The specifications on Page 30 list the permissible limits for mechanical, ther-
mal and electrical stress. It is essential that these are taken into account when
planning the measuring set-up, during installation and, ultimately, during op-
eration.
A1385−6.0 en/de/fr
11
HBM